Alle kategorieë
EN

home>Nuus>Industry News

Hot Produkte

  • AB-51 ~ 53
  • AB-460 ~ 463

Kontak Ons

ADRES:89, Yezhang Road, Wuqiao Community, Zhuanghang Town, Fengxian District

TEL:021-57407335

E-MAIL:[e-pos beskerm]

Watter faktore beïnvloed die uitstekende elektroplateringskwaliteit van sinklegeringsgietstukke?

Tyd: 2020-10-26 Treffers: 265

For zinc alloy die castings to be electroplated surface treatment, this link is very important. If the electroplating is not done well, all the work in the early stage will be wasted. Therefore, we must pay attention to the electroplating process of the product. Then the quality of electroplating is affected by those factors. Huayin Die Casting summarizes the following for you:

 

1. For the selection of raw materials for zinc alloy die-casting parts, regular national standard materials must be selected for product die-casting.

 

 2. The design of zinc alloy die-casting parts should be reasonable. The shape of die-casting parts should consider the concealing ability of electroplating, and try to reduce non-through holes, so that it is not easy to carry solution in water washing. Cut sharp corners and other parts to make the power lines evenly distributed during electroplating.

 

  3. The die-casting process and die-casting mold design are reasonable, so that the die-casting parts will not suffer from the shortcomings of shrinkage, pinhole and looseness. The above-mentioned shortcomings will directly affect the adhesion of the coating.

 

 4. In the production process of zinc alloy die castings, try to reduce the segregation phenomenon. If aluminum segregates in certain parts, aluminum will firstly dissolve during degreasing, which will cause pores and pinholes on the surface of the die-casting and cannot be cleaned, resulting in poor bonding strength, resulting in peeling and blistering of the coating.

 

 5. Pay attention to the scale during the grinding and polishing process. The fine layer of 0.05~0.1mm formed during the cooling process of the die casting is very important for electroplating. The loss of the fine layer should be reduced as much as possible during the grinding and polishing. If this layer is ground and thrown away, What will be revealed is the porous structure, and no good electroplating layer will be obtained on this layer.

 

  6. The copper-nickel-chromium electroplating layer composed of multiple plating types is a negative plating layer relative to the substrate. As long as the mechanical maintenance is effective, the zinc alloy parts will corrode in the humid air, so it is necessary to ensure that the plating layer is free hole. Otherwise, the corrosion products of the zinc alloy will cause blistering of the coating. Compared with steel parts, the plating layer should be thicker to be suitable for zinc alloy die castings.

 

7. Residues of die-casting parts during die-casting and machining should be cleaned up as much as possible after processing. Because the residue is a vivid metal, in any process of electroplating, it will react with the solution and damage the plating solution, which will affect the quality of the plating.


Warm kategorieë

KONTAK ONS